rccolt45 Report post Posted October 25, 2008 Hi guys, I have been make some holsters as a hobby for several months. Usually I just go and pick up some single shoulder (I think) 8/9 0z leather at Tandys. It was good for a start but I wqant to bump it up to W & C after reading some posts here. The problem is that when I go to their web site they have several choices for example, skirting leather or briddle leather etc. I thought all I would order was some single shoulder 8/9 0z leather but I don't even see that description on the site. Clearly I am not up on the lingo. Can anyone tell me what I should ask for? Also do I want shoulder, belly or back leather? Thanks in advance. Quote Share this post Link to post Share on other sites
ChuckBurrows Report post Posted October 25, 2008 Since you are making holsters (per your sig) - call them and order one of the following: 1) one of their new (to them) 8/10 oz tooling double shoulders 2) an 8/10 oz back (more expensive but VERY clean thus less waste) 3) an 8/10 oz tooling side - they currently have them on sale for $90.00 flat rate Hope this helps......... Quote Share this post Link to post Share on other sites
