Jump to content
rlpullman

Holster Gun Retention Hardware

Recommended Posts

I have seen several sites where they have holsters that have a type of retention adjusting screw. They look kind of like a Chicago screw with a rubber grommet. They are used to adjust the amount of retention on the hand gun. Does anyone here know of a supplier where I can get these?

Share this post


Link to post
Share on other sites

Local hardware store- You'll need a t-nut, a bolt, a finish washer (aka 'cup washer'), and about 1/2" of rubber hose from the plumbing section.

Share this post


Link to post
Share on other sites

Like Twin oaks said you can get pretty much everything you need at a hardware store or one of the big box stores. Below is a picture that shows pretty much every thing you need. If you don't want to collect everything you need you can get what you need from Rob Bennett the bluegunstore.com. Index fastners http://www.ifithermoplastics.com/category/fasteners also has everything you need.

post-15001-0-96530100-1425172072_thumb.j

Edited by camano ridge

Share this post


Link to post
Share on other sites

Thanks you guys. That's too easy

Share this post


Link to post
Share on other sites

I ordered all my hardware from here:

hasn't shown up yet, and I don't use hardware for retention but they had everything I wanted/needed and were way cheaper than the hardware store.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...