Jump to content
FHL FERG

Looking For Specs For A Sewing Machine...

Recommended Posts

post-18310-012450200 1336445567_thumb.jpI am looking for info on a Prosew Model M 120-2 cylinder arm machine. I need to know what it's capable of, foot type, lift, needle and thread sizes, etc...

Several google searches turned up nada...... :/

Edited by FHL FERG

Share this post


Link to post
Share on other sites

That machine resembles a Cowboy CB2500 and Techsew GA5-1. If this machine has the same specs, it can sew up to 7/16 inch of leather, using needle sizes 23 through 26 (plus or minus a size). It can handle thread sizes 138 through 346. Like the aforementioned machines, it will be bottom feed only, with a flat fixed presser foot and has a large cylindrical bobbin.

These machines are based on the ancient Singer 45k25. They are good machines for sewing just under a half inch, but where the tooth marks on the bottom are not normally seen, or considered unacceptable by the end buyers of the goods produced on the machine.

Edited by Wizcrafts

Share this post


Link to post
Share on other sites

Thanks so much Wiz

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...