Bluesman Report post Posted March 22, 2014 I got my new Cobra and am getting familiar with it. Today i wound a bobbin and wanted to increase the wind speed. So I watched the video, both the one that came with it and another on the Cobra site. Seemed simple enough. So i pressed and held the down button and it said 5.0. Then I pressed the down button again and it said 12. I hit the up arrow until I got 24 and the speed was much faster and I wound the bobbin. Now I want to go back to were I was which was 5.0 and 12. Well now I can't get back. When I hold down the down arrow I get 5.0 but hitting the up arrow it goes 5.1, 5.2 5.3 and so on. Then I also get L0, L1, L2. So what is all of this stuff, A manual would have really been nice. The videos brush over this area real quick. So can somebody tell me this. 1.) What is the 5.0, 5.1, 5.2 setting 2.) What is 6 - 24 3.) What is L0, L1, L2 And how do I get to them and what do they all do for me. This is way more confusing than it needs to be. Thanks Jon Quote Share this post Link to post Share on other sites
Bluesman Report post Posted March 22, 2014 Got it. Works now Quote Share this post Link to post Share on other sites
mexiconnect2013 Report post Posted May 14, 2015 How did you figure it out? 1.) What is the 5.0, 5.1, 5.2 setting 2.) What is 6 - 24 3.) What is L0, L1, L2 Quote Share this post Link to post Share on other sites
Joon1911 Report post Posted May 14, 2015 Umm. Mine came with a manual in the box with sewing head. If yours didn't then call Steve and I'm sure he'll send you one. It has directions in the back. If I have a chance I'll scan the page withe those directions. Quote Share this post Link to post Share on other sites
Joon1911 Report post Posted May 17, 2015 My how feeble my memory is these days. Finally remembered to scan the page from the Cobra C4 manual with instructions for the servo motor. Hope this helps. servo motor.pdf Quote Share this post Link to post Share on other sites
