BearMan Report post Posted April 1, 2009 Hello everybody, Here is my latest updated version, of my "Half Breed" knife. It's about half, of a Head knife, about half of a streight knife, & about half of a trimming knife. Hmmm 3 halves?? Well anyway, I use it to do rough cuts, finer cuts, & as a push & pull skiver. I've found this design to be very versitile. It's made out of an industrial knife blade, very hard, a file won't hardly touch it. It has a Cocobolo handle with a copper ferrell & brass pin. It's just over 5" long, with about a 2" blade. The top 1" & the bottom 2" edges are sharpened. A new "Toy" to add to my collection! Ed Quote Share this post Link to post Share on other sites