johnggrg Report post Posted May 22, 2014 I curently use an awl to punch my stitching holes. I am wondering about the diamond stitching hole punches. Are the shape of the diamond hole better? If so why? Does it make it easier? Any and information would be appreciated. John Quote Share this post Link to post Share on other sites
Hi Im Joe Report post Posted May 22, 2014 I find I make more consistent holes with the chisels then with the awl. Especially the backside. Quote Share this post Link to post Share on other sites
johnggrg Report post Posted May 22, 2014 Does it make the stitching easier? Quote Share this post Link to post Share on other sites
Hi Im Joe Report post Posted May 22, 2014 Well i mean it makes it more consistent. Which results in your stitching looking better. I find it easier to make neat holes with the chisel then with the awl. Quote Share this post Link to post Share on other sites
DavidL Report post Posted May 22, 2014 I have one in 9 SPI i don't use it at all since I got european pricking irons, they do okay. Quote Share this post Link to post Share on other sites
johnggrg Report post Posted May 23, 2014 for my normal stitches I use the large overstitch wheel to lay out my stitch marks. So would that be the 4mm?? I want to get the ones that are the same distance as what I am useing now. Quote Share this post Link to post Share on other sites
DavidL Report post Posted May 23, 2014 stitch with the overstitch, take a ruler and measure out how many stitches can fit within an inch. That is the Stitches per inch of your overstitch. Stitches per inch on pricking iron and overstitch are the same scale. Quote Share this post Link to post Share on other sites
johnggrg Report post Posted May 24, 2014 the ones I looked at said 2mm 3mm 4mm etc.Even Tandy's say's Pro Line Diamond Stitching Chisel 2 Prong (5/64" (2mm) Spacing) Quote Share this post Link to post Share on other sites
Glendon Report post Posted May 24, 2014 Check out the response to the question I asked here http://leatherworker.net/forum/index.php?showtopic=55198 Quote Share this post Link to post Share on other sites
johnggrg Report post Posted May 25, 2014 Thank you all for the help and information it is much appreciated. John Quote Share this post Link to post Share on other sites
St8LineGunsmith Report post Posted May 25, 2014 They have their place for some projects. Looking at a lefty's perspective... you have to use the chisel on the right side of the stitch to get a good stagger on the stitches I will use the chisels on thin projects best you can do with thick projects is to use as a pricking chisel then finish the hole with a stitching awl. most of my projects I will gouge a stitching channel then use the overstitch wheel in the channel then stab the holes in with a good sharp awl. Quote Share this post Link to post Share on other sites
RavenAus Report post Posted May 25, 2014 The 2.5mm chisel is 5SPI, according to my local shop. Checked em against the 5 overstitch wheel and it's as close as you'll get when they are on different measuring systems Quote Share this post Link to post Share on other sites
