Jump to content

dhawktx

Members
  • Content Count

    6
  • Joined

  • Last visited

About dhawktx

  • Rank
    New Member

LW Info

  • How did you find leatherworker.net?
    Bing.com search
  1. He stopped releasing new designs after '81 according to his site. He's just now released a new set. Very fresh looks totally different from others *cough Tandy*.
  2. Well, he's been making them for nearly forty years: http://www.kellymidasclassics.co.nz/
  3. Good point Tom! I was thinking acrylics and not volatiles. Looking at the Paasche, it appears to be a similar setup (exhaust past the fans).
  4. Good Old Barges Cement would hold them on just fine, especially since they are in protected recessed areas.
  5. We've used this portable unit that vents out a window with great success. If you need a larger area you can join two of them for about the same area as the Paasche for just a little more than you paid for your great find! http://www.amazon.com/gp/product/B00BMUH8L6/sr=8-3/qid=1375587893/ref=olp_product_details?ie=UTF8&me=&qid=1375587893&seller=&sr=8-3
  6. Hey there! I just joined tonight and I've been cutting garment and upholstery leathers with single passes on our Trotec 120W. We have also cut and engraved on oil tanned leather for a steampunk corset. With the 120W I generally cut at 45% power and a relatively fast speed of 3 and frequency of 15000 (not sure how that translates to other machines). Most of my leather cutting has been for a local 'special interest' shop and consists of letters to be appliqued and/or designs to have colored suedes applied behind them. While the laser DOES brown the edges, most of our clients feel that it adds a finished look to the piece. For Vegtan we mask the surface before cutting, so any smoke deposits will only be on the bottom. We've optimized our venting also, which helps get the smoke away from the material as quickly as we can. I generally use a temporary spray mount to put it on poster board and set it for a kiss-cut so the board stays together and no pieces are lost. The biggest No-No I've learned when lasering leather is trying to squeeze out an extra piece or two from 'spongy' leathers. Those are going to shrivel up on you.
×
×
  • Create New...