Sanch Report post Posted September 20, 2014 These are the mauls and mallets I use and made They are Delrin, wood table leg handles and leather handles the Black and cordovan mallets are my latest additions they all have SS acorn nuts and 1/2'' all thread shaft running through the length the weights go from heavy to light LOL! as always any and all comments welcomed Quote Share this post Link to post Share on other sites
Wishful Report post Posted September 22, 2014 Looks good, what did you use for weight s? Quote Share this post Link to post Share on other sites
Sanch Report post Posted September 23, 2014 I didn't put any weight in them other than the acorn top cap they are fine for me and that is what suits me! Quote Share this post Link to post Share on other sites
rlkey Report post Posted September 23, 2014 Those look great and I really dig the square face mallets. Where did you find the delrin? I've looked online but haven't been able to find a good source. Quote Share this post Link to post Share on other sites
cradom Report post Posted September 23, 2014 I would also like to know where to get Delrin. Quote Share this post Link to post Share on other sites
Sanch Report post Posted September 23, 2014 Piedmont Plastics is a good source gentlemen Quote Share this post Link to post Share on other sites
cradom Report post Posted September 24, 2014 Following that link I found this: http://www.eplastics.com/Acetal_Delrin_Rod 2 to 3 inches in diameter, by the foot. Not too bad. Wonder how much bounce it has. Quote Share this post Link to post Share on other sites
Sanch Report post Posted September 24, 2014 I have found the "bounce" to be just right for me but then I have never used anything but my hand made delrin mauls and now mallets..well I forget myself in comparison to rawhide mallets I can say I prefer the delrin any day of the week. the rawhide mallets I have are old osbourne mallets and very very rarely see any of my Gomph-Hackbarth tools or any of my cheap tools for that fact..They aren't balanced like my mauls and mallets........ Quote Share this post Link to post Share on other sites
cradom Report post Posted September 24, 2014 Thank you for the information. One last question. Did you bore it your self? How easy is it to drill, for example, can I do it without a press? Quote Share this post Link to post Share on other sites
Sanch Report post Posted September 24, 2014 A press is recommended to get a good straight hole but yes a hand drill will do in a pinch pilot hole an a good sharp bit. And get after it! Quote Share this post Link to post Share on other sites
