LeatherWerks Report post Posted August 5, 2013 I want to use 'Pull the Dot' snaps on a 1911 IWB holster I'm making. I found the snaps at Springfield Leather. So, the pieces are the Cap, the Stud and the Socket. What I would like to do is secure the Pull the Dot socket to the T-nut using a small screw. This might actually be the way its done but having never built this type of holster, I just don't know. What I do know is that on line 24 snaps, the screw that would fit inside the socket would have to be fairly small to fit inside and allow the snap to close. Can anyone shed some light on how this is normally done? Thanks, Steve Quote Share this post Link to post Share on other sites
Tree Reaper Report post Posted August 5, 2013 (edited) You can use a 5/32 screw but the problem you might have is getting a 5/32 T nut to match the screw. Edited August 5, 2013 by Tree Reaper Quote Share this post Link to post Share on other sites
