Jump to content
Sign in to follow this  
RichardCollmorgen

Checking a saddle tree

Recommended Posts

What is the best way to check a tree in a saddle? Should I pull the jockey and lift the seat to visually inspect it or can I stress it in a particular way and see if it gives? My nephew has a factory saddle by NRS. I suspect it has a fiberglass tree in it. His calf horse works well the first couple of runs each practice and then starts to quit working rope. A PRCA roper that he took a lesson from suggested that either the saddle might not be fitting well or the tree might be cracked.

Share this post


Link to post
Share on other sites

test the bars:: place the saddle nose down( horn down) on the floor and apply your weight to the cantle to see if there is any movement/flex.

test the fork :: place the saddle on its side on the floor and apply your weight on the top side to see if there is any flex in the fork ( usually would be under the horn) or cantle. You may have to apply all your weight .

I suspect it may be more of a horse issue that may or maybe not caused by the saddle.

It is usually hard to see a broken tree by looking under the jockeys..

Share this post


Link to post
Share on other sites

Thanks Andy. I'll take the advice.

Edited by RichardCollmorgen

Share this post


Link to post
Share on other sites

Richard........I agree with Andy all the way around. If you got a saddle stand or rack, you can grab the horn in one hand and the cantle in the other and push them toward each other. If the tree is broken, you can see and feel alot of movement. To visually see if the tree is damaged, you'd have to tear it down quite a ways to expose the tree.

As for the horse not working, I've run into the same dilema with my son who is 16. When he first started tying down, he had a horse that was supposed to be a real good tie down horse. The horse would work for a few runs and then quit. Finally, after alot of practice, when my son was stepping off better, the horse began to work again. Alot of calf horses quit working due to pilot error. Another factor may be his hocks and/or stifles. They can get sored up pretty quickly if you're running alot of calves. I'd probably lean more toward horse issues than saddle issues. And of course, every now and then, those horses just need some ol' fashioned tuning. You can PM me if you want about some of the methods we've used that work really well.

Good luck to you.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...