Jump to content
Flattracker

Leather Edge On Canvas Tool Roll?

Recommended Posts

I've not done a folded leather edge trim before to finish off the edges of a canvas tool roll. I've tried some sheep leather, it's turned nicely round the corners of the tool roll but I've had to cut 4 pieces! The multiple joins don't look good though.

What do you use for this type of finish, do you cut ever decreasing circles from the sheep hide or is there a cheaper alternative out there already cut for this job. I've been googling but mainly come up with bias binding and very expensive "per metre" faux leather which also isn't wide enough for what I need, 25-30mm.

I'd thought about using the canvas, cutting strips to edge it but it's a twill and frays and too thick to fold over (maybe?)

Thanks all

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...