Jump to content
cgleathercraft

3/4" Corner Protectors

Recommended Posts

Metal Corner protectors WAY too many to count.

$0.05 per piece + shipping

Depending on how many ordered I may cover shipping and give discount.

post-39990-0-01910800-1422920770_thumb.j

Share this post


Link to post
Share on other sites

No worries! Been there, done that myself :)

Share this post


Link to post
Share on other sites

What is the maximum thickness theses can be used on?

Share this post


Link to post
Share on other sites

I will get the measurement tonight.

Share this post


Link to post
Share on other sites

I wouldn't go more than 10 oz. They fit very cleanly on the 6 and 8 oz pieces I tried. 12 oz (two 6 oz pieces back to back) was too thick.

Share this post


Link to post
Share on other sites

Are you in the USA?

Yes Northern Missouri, about 1.5 hours north of KC

Are they easy to bend over?

I used a small tack hammer that I picked up at Menards. Light taps had them holding strong enough that it took pliers to get them off. I believe a small arbor press would work better to crimp them a little tighter but I don't have one to test with.

Share this post


Link to post
Share on other sites

I have about 3000 of these left. Every reasonable offer considered.

Share this post


Link to post
Share on other sites

PM sent

Bob Stelmack

Share this post


Link to post
Share on other sites

Sold, Pending Payment.

Share this post


Link to post
Share on other sites

Sold, Thank you everyone!

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

×
×
  • Create New...