Jump to content
Tex Shooter

Stitching Pony Concept

Recommended Posts

I had not seen a pony configuration like this, so I just threw together this pony with scrap to try it out. It is not finished and I will either tear it down and re-do it or tweak it quite a bit. It was meant as a concept prototype. The idea behind it is to clamp it to a table and then slide up to it to stitch. The pony as it sits works, but it could use some tweaking. A bolted on 2 inch by 1/8 aluminum angle Is what holds the clamp to the table clamping board. The tips have Barge glued vegetable tip inserts. It is strong and does not flex around. I will put more gap at the bottom for clearance and about make 2 or 3 inches shorter overall. The angle is mounted upside down to give more throat. I used a hinge at the bottom and found out that was a mistake. This is my first attempt at making a stitching pony and I have learned a lot. -- Tex

post-42291-0-82685500-1387718495_thumb.j

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...