Craftt
Members-
Content Count
63 -
Joined
-
Last visited
About Craftt
-
Rank
Member
- Birthday 03/30/1954
Profile Information
-
Gender
Female
-
Location
Missouri
-
Interests
what else is there but leatherwork!!
golfing,fishing
LW Info
-
Leatherwork Specialty
small projects
-
Interested in learning about
all of it
-
How did you find leatherworker.net?
cruising internet
Recent Profile Visitors
4,765 profile views
-
the handle on the cobra 4 bell skiver will not go back up after sharpening. thanks for any help
-
Thanks but I hope I never have to make another one
-
Finished the sheath with a wedge made from layers of leather.
-
Can’t change knife doesn’t belong to me.
-
Need help with knife sheath that has .5” between blade and guard? Do I just build up the outside edges tapering down to the point?
-
Craftt started following Cobra 26 bobbin help, Help with knife sheath and edge beveling inside corners
-
Need to know what to do when there is a .5” difference between blade and Guard
-
Great thanks to both. I did watch a lot of videos last night and I got the idea it was best to put a curve in it.thanks again and God Bless right back
-
i am looking for help with using the edge beveler on inside corners such as on a knife sheath that is folded over with the belt above the sheath. Places where there is a 90* degree inside corner where the beveler does not go all the way into the corner. thanks craftt
-
That did it thaks
-
Thank you I'll try tomorrow
-
Hi all I just purchased a cobra 26 and probably caused the problem myself but don't know what I did so I don't know how to fix it. I am getting loops on the bottom side of leather when I use reverse. Any help will be appreciated. Also is there a (factory set) on tension to begin with (like tighten all the way and back off one or two times) for both the primary and the bobbin?
-
Greetings and salutations from SW Missouri :)
Craftt replied to ComputerDoctor's topic in Member Gallery
Welcome being a sw mo person also. Sunrise beach. Try Springfield leather for some of your stuff and ask about the wholesale membership. I really enjoy the store. -
Patty i checked out your facepage and you are doing a very good job. Looks like you have the colors down ok. cindy
-
who of us have ever transposed letters in a name to ruin a project? I did recently but this was my solution for salvaging the project. the name Leah was to be under the bible, but i started it looking at the letters three times and still put the a before the e. there goes it!!!!!!
-
thanks for all the respones. i just did a guitar strap and did put it where the adjustment strap covered it. i do like the way it was incorporated into the pattern on the back. thanks all