Jump to content

piheart

Members
  • Content Count

    59
  • Joined

  • Last visited

About piheart

  • Rank
    Member

Profile Information

  • Gender
    Male

Recent Profile Visitors

2,315 profile views
  1. Thank you so much Art! You are right, I will try few different skiving machines, see which one is best.
  2. any suggestion from experienced leatherworkers? have been reading about skiving machine for long time, hard to decide which one should get .
  3. i wanna know the difference too! think im getting tired on choosing skiving machine now, any suggestions ftom experienced leathereorkers?
  4. Morning! Leatherwoker guys, Price for Consew dcs-3 and cobra np4 almost same, which one is better? I think dcs-3 has fortune knife.
  5. Hey! guys, Do you know where can I get accessories for Consew s3 machine? Like different size of feet and skiving knife or grinding stone . Best,
  6. piheart

    skiving machine

    looking for a cobra np4 or fortuna skiving machine in LA.
  7. Hi! Wiz, Glenn, DrmCa, Hockeymender, thank you guys for your help, we finally installed servo motor on the machine, got right one, quiet. now time to sew!
  8. Finally got some time! Went to sewing store, didn't get motor. The one in store has " electronic servo motor " tag, owner said it is family brand. When I try it, is different than mines. speed at 0, motor doesn't run ( mines runs ), at 350, little bit noisy, at 660, little bit more noisy, so higher speed gets nosier ( not that loud as my clutch motor, but still get little noise ). Back home, tried servo motor on my pfaff, put at speed 0, sew so slow, at 350, no noise at all, at 660, no noise at all, at 3450 no noise at all, quiet! Yours runs at speed 0? DrmCa.
  9. Thanks DrmCa! yes, I took a look at both motors, and saw difference as what you said. so need to figure out how to put servo on adler table when get it.
  10. Thank you vericone! I have done that yesterday, still gets 4mm at reverse max.
  11. 373 is 5mm. I have question, my reverse stitch - when max forward stitch is 5/6mm, reverse stitch only 4mm. when forward stitch is 4mm, reverse stitch is still 4mm which is good that two threads matches. forward stitch 3mm, reverse stitch is 3mm too. how it lost 1mm at reverse max stitch? anyone knows how to fix? I checked the leather that I used when I testing this machine from ex-owner, is also 1mm shorter, so I don't think is because I unscrew the nut little bit on top. Thank you guys!
  12. got 12mm now when lift knee level! Thank you Vericone! I just unscrew the nut little bit.
  13. will do that, wiz. Glenn suggested get 3 sizes vbelt, pick one that fit just right, if is 58'', then will get 56, 57, 58.
×
×
  • Create New...