Jump to content

Elliot

Contributing Member
  • Content Count

    142
  • Joined

  • Last visited

About Elliot

  • Rank
    Member

Recent Profile Visitors

10,723 profile views
  1. Elliot

    tools

    I bought them from someone selling His used tools, so don't know. Nice free turning tool, just need a better operator.
  2. Elliot

    tools

    I have 2 of those knifes , 5/8 barrels on them. To big for short turns, but nice wide turns.
  3. That tool has not been ground enough. You could spend 40 years with rouge to get a cutting edge. I have 2 or 3 I picked up with other tool sets bought from others. I even bought a new one they are all in the bottom of the junk box. You could wast a lot of time trying to make it work, send it back.
  4. Elliot

    Elephant leather

    #1 sold pending funds. thank you
  5. With that damage the shaft may be bent. Check that before going further. Good luck
  6. You have a very fix for cramping hands, may not work for everyone. I just tried it feels good in hand, had to slow way up tooling this afternoon. Thank you Rod
  7. Elliot

    Elephant leather

    I have been told a fully grown Bull, thin places 3/8 in to over 1/2 at the thickest. The wrinkles can be quite deep. takes much work to get hides down to belt thickness, without cutting into the wrinkles. I think 75.00 sq ft is cheep for the work involved. Rod
  8. Elliot

    Elephant leather

    #3 sold pending funds.
  9. Elliot

    Elephant leather

    #2 sold pending funds 1 & 3 still for sale
  10. Elliot

    Elephant leather

    The grid lines are 1 foot apart in the photos Prices per photo shipped flat-rate box lower 48 only Questions PM me 1# 85.00 2# 35.00 3# 85.00 . Below are close-ups. 1 & 3 are dark chocolate
  11. It looks to me that they are to be used in aluminum, or soft metal. You need a sharper thread for steel.
  12. If it was good, Tandy would not be selling at 200. Most of what they sell now make good paper weights or wall hangers. Another good use of Tandy junk, if you have a shop with a front counter leave a few tools scattered around. If they are missing when a so called customer leaves you have them pegged. I use to tear the corner of a 20 (50 would be better now) sticking out from under something fairly light. Some would tell you about it, others try to slip out, the look on their face price-less. Have fun!!!!!!!!!!!
  13. You haven't scratched the surface yet It gets worse.
  14. Will buy one press and both dies. How do you want to get paid? PM me with the details.
×
×
  • Create New...