JustWakinUp Report post Posted July 25, 2008 Hey everyone, I've been using the craftool edge slicker by hand for a while now. I thought I would give it a go by attaching it to a drill. If you've done this method before, could you please shed some light on the best method of attaching it to a drill. Thanks in advance. Quote Share this post Link to post Share on other sites
Timd Report post Posted July 25, 2008 1/4-20 x 2" bolt, stuck through the hole and bolted. Quote Share this post Link to post Share on other sites
ClayB Report post Posted July 25, 2008 I did mine the same way with the bolt. Just be careful when you try to slick with it because the plastic slicker will melt if you use too much pressure. Quote Share this post Link to post Share on other sites
HandyAndy Report post Posted July 27, 2008 I bought a 50 cent mandrel from Harbor Freight. Quote Share this post Link to post Share on other sites
