Accidental Water Stain Under Finish

[tporter]

I need a little help. This is my first time to post anything, hope I'm doing it right. Anyway, I am making a legal size folder for my stepson and I have already put the final finish of Neat-Lac on it when I realized I did not dampen tthe middle section to fold it over. I did and got too much water, now I have a water stain along the edge which, of course shows on the front and not the back. Also, I had already glued in the stiffener on the front. Does anyone have a suggestion of what I can do?

[Northmount]

Try letting it dry naturally, make sure there is good air circulation on both sides. I had forgotten to put the makers stamp on an item, remembered after putting neatlac on. Had not assembled it yet so dampened the flesh side to case it. Let it soak through so would have roughly the right water content, then stamped it. Let it air dry for a couple days and no stain or blotch. Maybe just lucky, but gradual air drying might work for you, even with the stiffener being wet.

Good luck. Hope it does well for you.

CTG