newdude Report post Posted October 25, 2012 Looking to make a few flyrod cases for friends, and would like to customize the hide(s) before construction. Leather will be approx. 1.5mm x 34" x 10". Name(s) to be tooled and painted, then background dyed diffrent color (usually black, some times tanned). Then perhaps a wheel pattern rolled in above and below the name. Diagram available upon request. I would say the letters could be stamped, but I've not seen any stamps over 1", and also not any fonts I like. So, although stamping may work, this will likely be a swivel knife job. I'll need about 2 per month. I can supply the leather, but may not have the choices and selection that some of/most of you folks have. Can anyone help? Thank you, Newdude Quote Share this post Link to post Share on other sites
Dwight Report post Posted October 26, 2012 I would like to at least take a look at it. I'm just outside of Waldo, . . . 10 miles north of Delaware, . . . 10 miles south of Marion. You can see some of my work at my website, . . . www.dwightsgunleather.com May God bless, Dwight Quote Share this post Link to post Share on other sites
newdude Report post Posted October 30, 2012 I would like to at least take a look at it. I'm just outside of Waldo, . . . 10 miles north of Delaware, . . . 10 miles south of Marion. You can see some of my work at my website, . . . www.dwightsgunleather.com May God bless, Dwight Tried to call, seems number is doscnnected. These would be quick and easy projects for anyone with average or better leatherworking skills. Anyone? Thanks, Quote Share this post Link to post Share on other sites
Dwight Report post Posted October 31, 2012 Newdude, . . . Try the numbers again, . . . both of them, . . . I'm home......... May God bless, Dwight Quote Share this post Link to post Share on other sites
