Rgn82 Report post Posted December 30, 2014 Hi. This is my first post on the forum and I didn't see this topic covered anywhere that I could find. Sorry if it has been. I just received my first Bowden saddle tree and when I set it on a flat surface, only three out of the four corners of the bars touch the table. The other one is about 1/4 to 3/8 inch high. Within tolerance? Seems like it may put uneven pressure on a horse's back. What should I do before putting more money into building this saddle? Send it back? Thanks for your help in advance. Quote Share this post Link to post Share on other sites
JAM Report post Posted December 30, 2014 Personally, I wouldn't use it. If you send it back for an exchange, you'll probably get another just like it. I'd look for a better treemaker - there are lists of them on the site here. Quote Share this post Link to post Share on other sites
Rgn82 Report post Posted December 31, 2014 Thanks JAM. I know there is a guy here in Bozeman that makes trees. I'll look him up. Quote Share this post Link to post Share on other sites