Tree Reaper Report post Posted April 15, 2014 I have a Tandy hand press with a set of dies for Segma snaps but no instructions. I think I have the cap dies on the right figured out but I'm not certain about the male side which I think is the set on the left. The male end might sit in the hole on one die and I'm not sure if the stud side fits on or inside the other die? Thanks. Kevin. Quote Share this post Link to post Share on other sites
WyomingSlick Report post Posted April 15, 2014 Wow, those are some "pricey" dudes ! You would think for that kind of money, they would include an instruction sheet. Maybe they figure it is like sex.......you should be able to figure out what goes where. LOL Quote Share this post Link to post Share on other sites
Tree Reaper Report post Posted April 15, 2014 I called the store and the manager pulled a set of dies from the store and we discussed the issue, I said I thought I had it figured out but didn't want to take the chance of breaking anything and he said if I did he would come good for it. RIGHT ON! This may help the next victim Quote Share this post Link to post Share on other sites
