Jump to content
angelren

Singer 29K51 Sewing Machine Help

Recommended Posts

Hello,

I have a Singer 29K51 sewing machine. Having loaded the bobbin, installed it in the shuttle, and closed the plate, I am having trouble getting the loop necessary for sewing which is created by the top thread and the bobbin thread. I have looked up pfds of the loading of the bobbin and shuttle and believe that I am doing it correctly. Can anyone give any trouble shooting suggestions? Thank you!

Share this post


Link to post
Share on other sites

Did you see this? The machine in this video is threaded left to right. Don't know how much that helps but It's fun to watch :)

Share this post


Link to post
Share on other sites

angelren these machines are wonderful, when they work but when they don't so frustrating. A few things they do thread left to right as stated also when pulling the bobbin thread bobbin should turn counter clockwise. I know that might sound silly but they don't sew otherwise. Timing is also important so with the cover open watch the needle as it starts to move up, the shuttle point should be at the edge of the needle. timing is adjusted under on the shaft that runs the to gear slides on the shuttle carrier. hope this helps.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...