IngleGunLeather Report post Posted December 7, 2012 Just wondering the distances you mark on your stamped or tooled belts when sewing on Cobra Class 4. I normally set my stitch line at 3/16" and use the left foot on non stamped or tooled belts. However, the 3/16" stitch line set up didn't work when I tried on some scrap that I had stamped. I changed to the right foot to prevent the foot from going over my stamp impressions, but then didn't have enough room towards the edge for the foot. So, can you tell me how you set up for this? -Do you use a left, right, or double foot? -What's your stitch line measurement from the edge? -Whats your border measurement from the edge? Stitch line marked at 3/16" , border at 5/16" and right foot Quote Share this post Link to post Share on other sites
dirtclod Report post Posted December 7, 2012 (edited) I use the left toe foot on 99% of everything i make. Never noticed it messing any of the basket weave up or anything else. I eyeball my where i mark for a stitch line but it's around a 1/4 inch. Edited December 7, 2012 by dirtclod Quote Share this post Link to post Share on other sites