Jump to content

Recommended Posts

Thought you might like to take a look at these two molded cases.

post-33768-0-15684600-1404352167_thumb.j

Share this post


Link to post
Share on other sites

Those are nice but please tell me more about your anti-gravity table!

Share this post


Link to post
Share on other sites

Dang ... I have no idea why the photos I post on this site or not oriented properly. Nor do I know how to fix it!

Share this post


Link to post
Share on other sites

Really clean nice work!

Share this post


Link to post
Share on other sites

lol, it's ok - even upside down those are some really nice sheaths. I have a gerber multi-tool I need to make a case for so I really do appreciate you sharing yours with us.

Share this post


Link to post
Share on other sites

Stitched at 7 spi and used a Dixon 1 1/2" pricking iron. I finally have the corners nailed and actually prefer to use the 1 1/2" iron rather than the 1/2" or two tooth iron I have. Finished with 7 spi overstitch wheel.

Share this post


Link to post
Share on other sites

LoyalNine, thanks! The leather is a little on the heavier side - 7 oz. i used it because I had a piece that was a little stiffer than norm and I thought it would suit this application well.

I out the belt loop together using Al Stohlman's, case making, volume one as a guide and use his standards for everything I do, concerning hardware attachment and loops etc.

Here's a pic - a little rough but it 'll get the job done!

post-33768-0-55517800-1404471105_thumb.j

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...