Jump to content
Modad2010

Question For Cas/sas Holster Makers

Recommended Posts

I have a guy that wants 2 El Dorado type rigs. I mostly do concealed stuff, so I went and bought the El Dorado pattern. It recommends using 9/10oz for the for the belt 8/9 for the holster and 4/5oz for for the liner and cartridge loops. I have a W/C double shoulder in 7/8oz. Would it be ok to use that doubled up for the holster and belt and then get some 4/5 for the loops or would I need to get three different weights to do these rigs?

Thanks,

Doug

Share this post


Link to post
Share on other sites

It would be fine. Two pieces 7/8 will be 14/16 and will be slightly thicker then the pattern is designed for just allow for that when cutting out your pattern. Are you making the two piece belt with the tapered end?

Edited by camano ridge

Share this post


Link to post
Share on other sites

(2)El Dorado rig? John Wayne holster? Right and left?

Billeted ends? ends of belt sewn on?

Share this post


Link to post
Share on other sites

Modad, if you are using the WIll Gohrmley Eldarado pattern pack. There are three belt patterns The first one is more or less a ranger belt with a Chape (buckle end) and the tongue (billet). The second one is a cobbled belt that started out as the first belt then extended by lacing a narrowed down (1 1/2") section to the main belt body. To me 7/8 oz unlined would be a little light for that style belt. 9/10 or above would be better. The third style belt is the rough out money/cartridge belt. 7/8 oz folded over would be a little heavy for that. You would have a difficult time getting a flat fold. FYI Spring field leathersells cartridge loop strips pre cut in different widths. I think around $5.00 for 50 or 60" strip. if you are only doing one or two cartridge belts it is cheaper then buying a 4/5 oz side to cut strips off of.

Share this post


Link to post
Share on other sites

the other option, although the springfield pre-cut options sounds cheap enough, is to take your 7/8 strip to a drum sander in your drill press.

Share this post


Link to post
Share on other sites

I'd almost forgotten about this post. Thanks for the replies. I actually used 8/9 with 4/5 for the liner on the holster, doubled up 8/9 for the belt with 4/5 for the cartridge loops. I am pleased with the outcome, but not satisfied. The customer actually ordered a third rig and all three were delivered this last evening. Here is a pic of the first rig.

post-41563-0-37519500-1429334617_thumb.j

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...