Jump to content

Steve

Members
  • Content Count

    25
  • Joined

  • Last visited

About Steve

  • Rank
    Member

LW Info

  • Leatherwork Specialty
    Saddles / Tack
  1. I've had mine for several years, it was money very well spent. Like Bruce said, the cantle binding attachment is a back saver. I also have the laser, it's handy enough, but I'm not sure I would replace it if it went out. Steve
  2. Trina Weber - http://weberstirrups.com/
  3. I have a 6" Dixon I will sell. Steve
  4. McMillen tools has them, at least a couple years ago they did. 864 Four Waters Dr. Sunrise Beach, MO 65079 Ph- (573) 374-7880 Steve
  5. What's on your mind?r

  6. Keith, if you don't mind me asking, where are you getting your shearlings? I've been less than satisfied with what I've been getting. Thanks; Steve
  7. I just cut the blade end off & weld on the other end of the handle. I tig welded mine, but if you don't have a tig welder I figure solder would probably hold up fine.
  8. Chris Cheney (Harwood Hardware) 1716 N 3000 W Rexburg, ID 83440 (208) 359-5860
  9. Yes, seems to be reliable, I've been doing it that way for several years with no problems.
  10. Steve

    Landis 16

    You can try oldcowpoke.com, he had several 16's last spring
  11. Yes sir, that sure answers my question. Thanks a bunch, stamping bindings isn't my favorite job. On the bench should make it quite a bit better. Thanks again Steve
  12. If you are going to stamp a binding on the bench, do you fit it up and establish the borders, then let it pretty much completly dry before taking it off? How do you handle the stretch, tape, glue it to plexiglass or just deal with. Thanks in advance Steve
  13. Who's Latigo are you using for strings & tie straps? Steve
×
×
  • Create New...