Jump to content
Sign in to follow this  
iamasmith

Transfer Of Beeswax From Thread To Leather Whilst Stitching

Recommended Posts

I made a project recently (only my second) but I put a lot of effort into the stitching and was turning the piece constantly in my hands whilst working with it. It was a small folding knife sheath with a lot of stitching and I'm not sure that a stitching pony would have been of any help here due to it being wet formed with close seams (which I trimmed also).

By the time I had finished I was conscious that the Beeswax in the thread that I had been using had polished the stamping and the sides of the piece quite considerably so I was a little nervous of the dye taking evenly.

It didn't and I didn't like the look of the piece at all. In the end I buffed most of the dye off afterwards to leave a kind of antiqued look but was wondering if this is a common problem and how you may re-prep a piece for a solid tone of dye if there has been some wax transferred... or is the answer to glue the piece, dye it and then stitch it??

The piece in question, that raised the question is...

5331024708_8f0b1af408_z.jpg

Share this post


Link to post
Share on other sites

Did you use pre-waxed thread?

This is what I have learned about using pre-waxed thread:

You need to rub it very briskly between 2 layers of brown paper before you use it. Rub it between the paper so fast and hard that you are about to burn your fingers!

This heats up the wax and drives is deeper into the thread, while removing the excess at the same time. Look at the paper after you are finished, and you will see just how much extra wax is on that thread.

Also, I wash my hands OFTEN during hand stitching, especially if doing a large project. Helps keep the dirt, oils and wax from transferring onto your project.

Share this post


Link to post
Share on other sites

Cheers Hilly, yes it was prewaxed thread and I hadn't heard that tip.

Many thanks,

Andy

Share this post


Link to post
Share on other sites

Good recovery!

Ditto above.

I usually clean up the stitch area with some denatured alcohol or DeGlazer.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...