GuardianConcealment Report post Posted December 7, 2014 Have a few duncan cast molds I am not using. $25 each shipped via paypal All have the front sight ground down to allow for sight channels 1: M&P Shield 2: Glock 27 3: Springfield XD 4: Springfield XDS 5: Smith and Wesson J-Frame Share this post Link to post Share on other sites
GuardianConcealment Report post Posted December 7, 2014 - XDS is SPF to Greystone Share this post Link to post Share on other sites
Colt Hammerless Report post Posted December 7, 2014 I'll take the Shield. PM inbound. Share this post Link to post Share on other sites
GuardianConcealment Report post Posted December 7, 2014 Shield SPF to Colt Hammerless. He also requested seconds on the XDS if Graystone does not purchase. Share this post Link to post Share on other sites
GuardianConcealment Report post Posted December 7, 2014 Rest of the molds are spf...that was quick and easy. Share this post Link to post Share on other sites
Colt Hammerless Report post Posted December 14, 2014 Got the Shield mold Guardian. Thanks! Paul Share this post Link to post Share on other sites
TwinOaks Report post Posted December 14, 2014 Just a question here, but why were the front sights "ground down for a sight channel"? You need to have something on the top to make the channel, and grinding off the thing that indicates height and center line doesn't make sense to me. Share this post Link to post Share on other sites
GuardianConcealment Report post Posted December 14, 2014 I used these for kydex and installed square rod for the sight channel. I cut all my sights off and extend the rod past the end of the muzzle. All are sold Share this post Link to post Share on other sites
TwinOaks Report post Posted December 14, 2014 Thank you for the reply - extending past the barrel makes a ton of sense, I just wasn't thinking in that direction.... OUCH......learned something new. Share this post Link to post Share on other sites
