Jump to content

Recommended Posts

round base 100mm, about 140mm high. Took ages to calculate the holes and spacings.

post-51851-0-46073000-1438250163_thumb.p

Share this post


Link to post
Share on other sites

Nice pouch. What kind of leather is it? I haven't tried this out yet, what made the hole measurements so difficult?

Share this post


Link to post
Share on other sites

Oooohhhh hahahahahahahahahahahhahahahaha so I guess I didn't read the title of your post, nix the what kind of leather question

Share this post


Link to post
Share on other sites

I purchased a 4oz bag of deerskin remnants from local Tandy Leather (5046-08) to see what the leather was like before buying a whole hide which is expensive here.

The stitches are 8 per inch - about 3mm apart and about 5mm in from edges. As apprentice, took me a while to figure out the inner circle circumference and number of stitch holes needed, then to find a piece long enough to match the required circumference plus 10mm to allow for side seam.

I've made a few other small items from the scrap as well.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...