Jump to content

dpate

Members
  • Content Count

    1
  • Joined

  • Last visited

About dpate

  • Rank
    New Member
  1. I acquired one of these recently as an amateur to the industry. Was a complete rust bucket mostly on the outside. I worked a little every night to clean and free up the pieces and parts. I feel I saved it just in time because most of the tolerances seem to be ok for what I know..considering I have had to build some of my own parts and figure this out with very little available info. I was wondering if there was any clearance or adjustment specs out there to help me fine tune this recovered gem? Wish someone would've posted a video on youtube. The only one I found wouldn't play for me. I have it stitching by hand but finding needles has been tuff. I have had to craft my own so far. Any advice or info would be highly appreciated and rewarded with karma. Thanks for your wisdom and pics above. Huge help to me when fabricating my pieces!!
×
×
  • Create New...