Quick Draw Holster For Model 28 Smith & Wesson

[George B]

Howdy all,

I need to make a quick draw holster for a S&W Model 28 with a 4" barrel.

I have a pattern from the Tandy Busacero book but it has a finger slot for the trigger.

I do not have acces to the weapon and could use a little advice on how to modify the pattern I have.

Anyone with experience with this?

[katsass]

Howdy all,

I need to make a quick draw holster for a S&W Model 28 with a 4" barrel.

I have a pattern from the Tandy Busacero book but it has a finger slot for the trigger.

I do not have acces to the weapon and could use a little advice on how to modify the pattern I have.

Anyone with experience with this?

George: from the grumpy old man.......here's a pic of a rig I did for a Colt DA wheel gun back in about 1978. The pic isn't too good because it is a digital taken of a 35mm print. I drew the design for it but have no idea where in the world that pattern may be. Maybe this helps a little? Mike

Edited March 9, 2011 by katsass

[George B]

George: from the grumpy old man.......here's a pic of a rig I did for a Colt DA wheel gun back in about 1978. The pic isn't too good because it is a digital taken of a 35mm print. I drew the design for it but have no idea where in the world that pattern may be. Maybe this helps a little? Mike

Hi Katass, yeppers, that gives me a better idea of where the trigger guard will be. When I did the modified pattern I thought the area around the rear sight looked a little funny, but now I see by the pic it is right. Thank you very much, it was very helpfull. George