CowboyBob
Contributing Member-
Content Count
3,136 -
Joined
-
Last visited
About CowboyBob
-
Rank
Sewing Machine Dealer
Contact Methods
-
AIM
sewmun@aol.com
-
Website URL
http://www.tolindsewmach.com/
-
ICQ
0
Profile Information
-
Gender
Male
-
Location
Toledo,Ohio
-
Interests
We sell New & Used
Leather Sewing Machines
Parts,Needles &Thread
LW Info
-
Leatherwork Specialty
Can help w/sewing machine questions & supplies
-
Interested in learning about
People needing help with machines
Recent Profile Visitors
55,535 profile views
-
If you loosen the needle set screw how far does the needle move left to right?
-
Thought some of you might like to see which machines compare to each other. Industrial machine comparison chart.pdf
-
Mitsubishi LU2-4710 leather thickness limit
CowboyBob replied to ValleyLeather's topic in Leather Sewing Machines
On this machine with #92 thread approx 5/16" or 20 oz of leather. -
There's a free classified section for used machines on this site that works good.
-
Any one hooked up a needle position sensor on a 111w?
CowboyBob replied to Billfromnc's topic in Leather Sewing Machines
We have this screw in stock Singer#200006 17/64 x 24tpi.It's 3/4" long -
We sell the same needle for $16.00 a pack of 10
-
No that is the same,the 156 has another button on top.Like I wrote on FB either the belt is on wrong or the cams aren't in the slot on the bottom shafts.
-
Still adjusts the same,the only difference is the 156 has a push button to adjust the height of the foot walk on the top.
-
@jsfarm 211g165 manual.pdf There's 2 -ways to adjust the machine to feed in reverse,first check that the timing belt is installed correctly as shown on page #24 in this manual.If not when you adjust it so it is you'll have to re-time the hook.
-
@shazbaz There's a service info on the 111w in this file,you have to scroll some to find it. Navy_Repair_manual_on_31-15,111w,199_zig-zag.pdf
-
Are you holding onto the needle thread for the first 3 stitches?
-
Singer 31-19 timing the feed dog to kicking foot
CowboyBob replied to SingerDad's topic in Leather Sewing Machines
If your sure that's correct you can rotate the cam on the top shaft(there's 2 screws,one might be in a slot on the shaft),the one in the back where the rod comes out.IDK which way you'll need to turn it but try one way & if it gets better you got lucky if not go the other way. -
Singer 31-19 timing the feed dog to kicking foot
CowboyBob replied to SingerDad's topic in Leather Sewing Machines
Are you sure the feed timing is correct?You want the feed dog all the way back & starting to go down as the needle enters the material. -
Looks like the feed cam slipped 180,this is the cam on the rightside on the top shaft underneath the oblong plate.It have 2-screws,loosen both & put the screwdriver in one screw to hold the cam & turn the handwheel half way around,snug one screw & check the feed it should be close,adjust one way or the other as needed.
-
Pfaff 145 different hooks. What’s the difference?
CowboyBob replied to SingerDad's topic in Leather Sewing Machines
Sure can.