Jump to content
KGeorge

Tooling The Gullet

Recommended Posts

I was wondering if anyone could share their process for tooling the gullet? I can't figure out a good way to do it. Would you tool it after cementing it in and while it's still cased on the saddle tree or fit it in let it dry and then take it out flatten it just enough to tool it then fit it back it permanently?

Share this post


Link to post
Share on other sites

If you want borders around the tooling, than it is best to tool it after it is installed. No need to stamp immediately, you can re wet and stamp it after the swell cover is installed and skirts are fit for border placement. If you don't need borders, than you can stamp it past the edges flat on the bench, and then install.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...