Jump to content
Sign in to follow this  
mattsh

A Few Recently Finished Ones

Recommended Posts

Here are a few that I finished recently.

One for me, which was a test piece for the Glock 19 to get the stitching just right and as you can see I needed to move the corner of the trigger guard up about 1/4", which I did on the IWB with snaps that is pictured below. Sorry the picture is slightly out of focus. My phone camera didn't want to cooperate on this one.

post-5907-036567100 1320186568_thumb.jpg

This is for a friend's brother-in-law. As I noted above I adjusted the stitching line and now its much better.

post-5907-072100400 1320186642_thumb.jpg

This is for a friend at work. His pistol is actually a stainless Springfield. But boy I sure like how that blued customized Colt looks in there.

post-5907-080291600 1320186765_thumb.jpg

Share this post


Link to post
Share on other sites

Wow! That wrong handed rig is a looker. Nice job.

Share this post


Link to post
Share on other sites

Thanks Hays. It did turn out really nice, even though its for the wrong side. :P

Share this post


Link to post
Share on other sites

That is some nice work. That bottom southpaw rig is nice looking.

Share this post


Link to post
Share on other sites

I like your stitching on that belt a lot, what thread size is that? I'm curious what your lining it with as well. Nice work!

Share this post


Link to post
Share on other sites

Eaglestroker - I wish I could answer your questions with certainty, but I can't. I should have prefaced the picture with the statement that the belt was not made by me. It is a very nice belt, it was made by a man in Colorado. I was able to buy it cheaper than I could make one, so I did.

The thread looks to be 207 or 138, hard to say since I have never seen those sizes, but I know it is smaller than 277.

The lining would appear to be almost like a chrome tanned leather it is so soft, but like I said, not entirely sure. Sorry.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...