Sign in to follow this  
sinpac

Landis Model 30 Question

Recommended Posts

How do I remove the handle from the drive pinion stud. I removed the bolt and I know there is a key in there. I tapped the handle with a nylon hammer in hopes of removing it, but it will ot come off. Is it possible there is a burr on the drive pinion stud cause from the handle slipping. You guys have any ideas?

Chris

Share this post


Link to post
Share on other sites

Hi Chris

I had the same problem, used a puller to get crank off. then filed shaft nice and smooth. Solution: made a flat spot on shaft and drilled a dimple on flat spot, so set screw will sit. Tightened to prevent crank from turning. Problem solved.. You are working with cast.....easy on the hammer.

Good Luck Leo.

Share this post


Link to post
Share on other sites

Hi Chris

I had the same problem, used a puller to get crank off. then filed shaft nice and smooth. Solution: made a flat spot on shaft and drilled a dimple on flat spot, so set screw will sit. Tightened to prevent crank from turning. Problem solved.. You are working with cast.....easy on the hammer.

Good Luck Leo.

Leo I got it out. It is so gulled up I have to take it into a Machine shop and have the drive pinion stud remaned. When I get it back I will be drill a dimple in the flat spot so the bolt will seat proper. Thanks for the idea.

Chris

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this