Jump to content

Cornbread

Members
  • Content Count

    1
  • Joined

  • Last visited

About Cornbread

  • Rank
    New Member
  1. Hello all, I joined the sight a couple of years ago and did a little research on making holster and working leather. I made a couple of attempts at making holster but resulted in one butchered piece of leather and one pancake vice grip "holster" both of which went into the trash and hung up my leather working hat. So this Christmas I decided to try my hand at it again. I researched more and this is my 1st real functioning holster. Couple things I noticed. My Stitches are crooked in some areas, a groover and an oversticher things would help a lot. I need to work on my burnishing. Need more patience. Have a question too. The rough side of the leather was very "fuzzy". I ended up pulling up alot with a plastic brush on my dremel then burning it out. What it a better way...skiver? I hope i got my terminology right. Thanks for yall's critisism!
×
×
  • Create New...