Search the Community

This is the latest design I have come up with for the same customer I do the wedding ring boxes for. These are just a few pictures of some steps involved in making this one. I have now got an order for a run which I will take some more detailed pictures as I go along. There is a bit of 3d printing for the shell parts and tray dividers and a bit of laser work for cutting out the strawboard filler pieces and cutting knives still to be made. Note the pouch stud for closure and tab Might make an interesting bag design yet. This pic below shows the base shell just printed with the hole for pouch stud later addition. Here all of the pla parts are shown after printing. Sorry I covered the 2 little dividers before remembering to take the picture. The shell closest on the bottom right is for the tray and note that there is holding slots incorporated for the dividers. Here the tray has been leather covered and velvet base and sides installed. I am here only sliding the dividers in dry. Note there is a small gap in the velvet wall join I need to get better. Showing velvet and foam joined and sliced to make good curves The foam and dividers will be removed and glued in later after final measurements are taken. If you would be interested to see a more complete breakdown on how its made here let me know.