Search the Community

Hello, I've been following this forum for a while and it's fantastic. I have a JUKI LU-563 which is working quite well except for the fact that sometimes the upper thread catches on the bobbin case in the little nook. Anyone have any idea how to solve this problem? Thanks so much.

Long story, but here's the quasi short version ... Always been a hobby craftsman, wood work, welding and metal fabrication, electrical, plumbing, ranch construction, tractors, and a little sewing on the side ... etc. etc. I grew weary with a cheap Brother machine after repair and tuned ups, moved onto Janome HD1000. Happy with it, except for anything heavy (thread and/or fabric). So I purchased a Juki LU-563 with a new servo, bobbin winder, foot pedal, knee lifter, thread stand, led lighting, and various storage add-ons. Using scrap steel (1x3 schedule 40 structural tube) I had in my shop, I've fabricated a really stout table frame. I'm refinishing a 300 lb sold wood door as the table top (approximately 3' x 7'). I plan to end up with a pretty large and yet semi mobile (frame has casters) industrial sewing set up. I'm at the stage now to start assembling the technical stuff and I have a few questions you MIGHT be able to help with. CUT OUT - Does anyone know where I could find a cutout pattern for the table top? Ideally something specific to Juki 563, but if not then even something generic would be a great starting point. VIBRATION - My set up will end up weighing 400+ lbs and should be very stable, but I still have concerns about shake/rattle/vibration. I plan to set up the table on top of a 1/2" dense rubber floor (commercial gym flooring) and I am also using cut pieces of the same rubber mat between the wood table top and the steel framing, again to reduce vibration transfer. Any thoughts, is this overkill as usual? V-BELT LENGTH - What the heck is the standard/typical length V-belt most commonly used for a servo-juki set up like this? I figured there would be a couple of standard sizes, but found there are seemingly infinite variations! TOP FINISH - Table top finished with HD "heavy traffic" gloss urethane? Any thoughts on how this will serve the sewing purpose? My thought is the gloss will make moving fabric around much easier and a prefer the natural wood look over anything painted, especially when the wood looks great already! 110 OR 220 WIRING - new servo is 110 wired, but I know with my table saw I had it rewired to 220v and it has been more reliable and significantly more powerful. Anyone had a new/modern servo set up for 220v? HEAD LOCATION - I was planning to mount the machine toward the lower right hand corner of this larger table top, leaving more space on the left for fabric maneuvering but thinking about it last night, I started thinking that right in the middle might give me even more flexibility. What am I missing here? Apologies for asking so many questions all at once, my top question right now is really the cutout pattern (#1) but the others are semi-dangerous ideas bouncing around in my head! LOL PS ... I will post some pictures of the table, motor and head when I get a chance. That might help your understanding too.

Didn't know a 563N existed. Have an opportunity to purchase. How does it compare to the 563? Would you expect a good price to be more, less, same?

Hi, I found a deal on a Juki 563. From my reading it looks to be a subclass -3 I.E.: no reverse in lieu of extra long feed and thicker thread capacity. I have not found any details on how long the stitch length or thread capacity actually is. Does anyone have the skinny on these 563-3's? Thanks, Robert