vahillbilly Report post Posted January 23, 2010 I recently picked up a consew 225 and can not figure out how to adjust the tension on the bobbin. According to the manual, you adjust it with the screw outside the bobbin case, but I can't figure out what screw they are talking about and there is no diagram. Any help would be appreciated. My knowledge of sewing machines in very limited. Thanks, Sam Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted January 23, 2010 There's 2 screws on the bobbincase & it's the one on the left that adjusts the tension. Bob Quote Share this post Link to post Share on other sites
vahillbilly Report post Posted January 23, 2010 Here are pix from the front and back of bobbin area. Can you point out to me where these screws are? Thanks, Sam Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted January 25, 2010 This pic should help,it's screw marked AC.Click on the pic & it'll open up larger. Bob Kovar Quote Share this post Link to post Share on other sites
vahillbilly Report post Posted January 26, 2010 Thanks Bob. That is exactly what I needed. Sam Quote Share this post Link to post Share on other sites
CowboyBob Report post Posted January 26, 2010 Sam, Your Welcome,We are a Consew Dealer & have alomst all the parts in stock for it too,along w/needles & thread. So let me know if you have anymore questions. Bob Kovar Quote Share this post Link to post Share on other sites
