Jump to content
Sign in to follow this  
Gawdzilla

I Have No Idea What This Tool Would Be Called.

Recommended Posts

I'm looking for a tool that will put a small curve on both sides of a cut. If you've ever seen the stylized "double bow" that is used to suggest birds, that's what I would like to have.

Any clues for Googling would be appreciated.

Share this post


Link to post
Share on other sites

Look for "Veiner Stamp"

Share this post


Link to post
Share on other sites

Look for "Veiner Stamp"

Thanks, I'll check it out. Sorry, that's now what I'm looking for. This stamp would have a gull-wing profile to it, so both sides of a cut would be curved at the same time. I need it for places where neither side of a cut should be lower than the other, but definition of the cut is needed for emphasis.

Like this, but curved, not flat.

6997-00-M.jpg

Edited by Gawdzilla

Share this post


Link to post
Share on other sites

Hmmm - maybe a little work with a "rat-tail" (round) file would give that stamp the curved faces that you are looking for?

Share this post


Link to post
Share on other sites

Hmmm - maybe a little work with a "rat-tail" (round) file would give that stamp the curved faces that you are looking for?

I'm grinding a stainless steel bolt down to see how close I can get without doing any real work.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...