Help Locating A Holster Swivel

Recommended Posts

On 4/30/2019 at 3:28 PM, Jimmy McLaughlin said:

Thank you for the hardware tip, just what I was looking for. How does the end close up?

I apologize for the delayed response to your question,
The swivel hardware is set similar to a copper rivet and burr. The post has to be flared over the washer but Standing Bear's Trading Post does not sell a tool to do that, you can try peening it over the washer with a hammer after you cut it to length. The post should be about 1/4" past the washer, the washer should be pushed down tight against the leather. Hope this helps. 


Share this post

Link to post
Share on other sites
On 4/22/2019 at 1:46 PM, AA3JW said:

I am working on  the exact holster in the picture. Looked at the web site for Standing Bear's Trading Post could not find that screw/rivet. What do they call it, and where would it be on their site?


Because the item is special order, Standing Bear's Trading Post does not have it listed on the website. To order, please contact the shop direct at 818-342-9120 or via email at

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now