Jump to content
Sign in to follow this  
cowboy bill

2 111'2 Inch Stirrup Neck

Recommended Posts

can i take a wood galvanized metal covered blank and tighten the bolt to get neck down to 2 1/2 in size from the standard 3 inches ?? thanks BILL

Share this post


Link to post
Share on other sites

I have done it with a monel covered oak stirrup from Weber. Be sure to use a new pipe spacer 2 1/2" wide. It should work fine for your stirrup as well.

Share this post


Link to post
Share on other sites

Cowboy B,ill

I use a tubing cutter to cut the 3" spacer down to 2 5/8" . Once the bolt is tightened down cut off with a hacksaw and peen with hammer.

Ben

Share this post


Link to post
Share on other sites

thanks for the reply, i figured i could do that but i never had that problem before. BILL

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...