nando Report post Posted February 12, 2014 (edited) I have a 2 ton manual arbor press and I wonder if I would be able to nicely cut 3-4 oz (1-1.5 mm) leather, using a steel rule cutting die or solid die. I would appreciate any input. Thanks, Nando Edited February 12, 2014 by nando Quote Share this post Link to post Share on other sites
Northmount Report post Posted February 12, 2014 Depends on the size of the die. Tom Quote Share this post Link to post Share on other sites
nando Report post Posted February 12, 2014 Thank you Tom. Good point. The die is circular (18.5cm - diameter) Nando Quote Share this post Link to post Share on other sites
Northmount Report post Posted February 12, 2014 One a 1 ton, can do something the size of a Rolodex card with no trouble. So for a 2 ton, you might be stretching a bit. Comparing the length of the cutting edge, 10" is okay for the 1 ton, you would be cutting about 20" with your 6" circle. Probably doable. You need a good solid plate above and below, a suitable cutting board, and enough throat depth. I need to get a couple small dies made for my 1 ton, and a couple lager ones plus plates for my 20 ton shop press. Always more stuff to do! Tom Quote Share this post Link to post Share on other sites
nando Report post Posted February 12, 2014 I really appreciate your input Tom. Thank you! Quote Share this post Link to post Share on other sites
