Svey302 Report post Posted November 30, 2016 I have been playing with the designs suggested previously, shortening the neck. Seeing Monicaj origami help me understood, finally. For some weird reason, I assumed that the ears were crossing (left to right, right to left). I will refine my pattern and built a few prototype to refine the keyfob. I will work with Northmount's design. NVLeatherWorx makes a good point about optimizing leather usage. I appreciated all the help I received. Merci, Yves keyfob shorter neck.pdf Quote Share this post Link to post Share on other sites
Svey302 Report post Posted December 3, 2016 4th prototype, 1st made in leather. I need to refine my edge finishing on the round ears. Tx for everyone's help, Yves Quote Share this post Link to post Share on other sites
mayorblurps Report post Posted December 21, 2016 On 12/3/2016 at 2:52 PM, Svey302 said: 4th prototype, 1st made in leather. I need to refine my edge finishing on the round ears. Tx for everyone's help, Yves So is the bottom part actually a larger piece folded in half? Or is it just one piece with the loop at the top wrapped around? Quote Share this post Link to post Share on other sites
Northmount Report post Posted December 21, 2016 One piece of leather, split from bottom to a point in line with the screw. Follow my pattern and advice posted above. Cut on the line marked as a fold line. Look real close at the picture you quoted and you can see what is cut, and what is folded. Might be hard to see if you are looking at it on a phone, go to a larger screen, or zoom in. Tom 13 hours ago, mayorblurps said: So is the bottom part actually a larger piece folded in half? Or is it just one piece with the loop at the top wrapped around? Quote Share this post Link to post Share on other sites
