AzShooter Report post Posted January 9, 2021 (edited) I had to scrap the other holster, it turned out to be too tight for it's needs so I really measured this one well and once I cut it I placed the gun in to make sure it's going to fit. The large cutout in the center is because of the electronic sight being used. I'll post with gun when complete. e I did the initial stamp with a Tandy Stamp. The basket weave stamps are from Weaver Leather. It's dyed with Saddle Tan, then Antiquing and then a coat or Resolene. The right side is high because for the type of shooting it's used for the trigger guard must be covered. The left is short because of an adapter on the gun and to prevent hitting the magazine release. Any criticism is welcome. Edited January 9, 2021 by AzShooter Quote Share this post Link to post Share on other sites
AzShooter Report post Posted January 14, 2021 Finally completed with gun inserted. Quote Share this post Link to post Share on other sites