Having Problems attempting to feed thread down thru the feed hole to the needle on Adler 30-15

[Demps]

Does anyone have an idea as to what causes it to become difficult to get thread thru feedhole on top of machine to the needle?  Does anyone have a parts diagram for this needle/feed assembly?

  

[Constabulary]

Do you have a manual? Are you using a threading wire? There is a paddle spring at the end of the needle bar you only an pass with a proper threading wire.

[Wizcrafts]

You can buy the same threading wire as is used in Singer patchers. They have a finger loop on top of a thin rod that has a split cut into the bottom. The split holds the thread as you push it through, past he paddle spring, to the needle.

[Demps]

Thank you for your response.  Glad to see you can purchase these threading wires thru Amazon.