JLSleather Report post Posted May 6, 2021 to clear out before vacation. Leather, pre-cut parts, strips, alphabet sets, dummy guns, will likely be some small hand tools, and even a couple of HF presses and some dyes 'n' such if you're local (I can't be bothered to ship those things). Get a good deal here, or it goes on the wife's sale coming up. Photos to begin shortly ... Share this post Link to post Share on other sites
JLSleather Report post Posted May 6, 2021 (edited) Alphabet sets. All complete with little wear, includes handles. CLICK photo to enlarge. About half of retail. $10 ships one set or all! 1" alphabet ........ $25 alphabet ..... $20 1/2" alphabet ..... $16 1/2" numbers ..... $10 each set (2 sets of these, apparently I needed 2 5's) 1/4" alphabet ..... $10 Edited May 6, 2021 by JLSleather Share this post Link to post Share on other sites
JLSleather Report post Posted May 6, 2021 (edited) Tough to get a good photo without setting it up better -- laying on the floor on a white board, this is precut leather for 3 holsters, 5 mag pouches, and a set of 6 coasters (w/c dark brown english bridle). INSANELY clean Hermann Oak A grade holster leather makes 2 "curved pancake" holsters and an "avenger" holster for the S/W shield 9, RH. Mag pouches include 2 large and 3 small -- so think 1911, Glock 17, Sig 226 for larger versus shield 380, sig 238, P938, pm9, lcp, etc... $50 gets it ALL (this is about 4 sq feet of A grade stuff, with NO waste) Edited May 6, 2021 by JLSleather Share this post Link to post Share on other sites
JLSleather Report post Posted May 6, 2021 Lace - all leather several spools of 3/32" - 2 black 1 brown 1 spool 3/16" buckstitch lace, black 2 partials latigo lace, 1/8" and 1/4" ALL for $30 (if I remember right, the buckstitch roll was more than that on its own) Share this post Link to post Share on other sites
JLSleather Report post Posted May 6, 2021 stamps - 9 fer $20 - yu pay the ship you prefer Share this post Link to post Share on other sites
DaltonMasterson Report post Posted May 7, 2021 Dummy guns and press pics yet? Share this post Link to post Share on other sites
JLSleather Report post Posted May 7, 2021 8 hours ago, DaltonMasterson said: Dummy guns and press pics yet? Uh, no -- presses are from Harbor Freight, the 20 ton floor press and a 6 ton table model. HF is more than reasonable and they're everywhere - so I'll let these go reasonable but they're already not bad so I would make the trip here if thats ALL a guy wanted. Still, a guy picking up presses could get a crazy DEAL on some Wickett/Craig leather The table model is about 30" tall and inside measurement about 10 1/12". 6 ton bottle. The dummy guns are mostly Rings, pretty standard stuff (though I may do the site channel a bit different than some folk). $38 or 3/$100 Got a model you're looking for, lemme know Share this post Link to post Share on other sites
JLSleather Report post Posted May 7, 2021 Alphabet sets is SOLD Share this post Link to post Share on other sites
JimNiner Report post Posted May 7, 2021 Hello, I'll take these if they are still available. Quote INSANELY clean Hermann Oak A grade holster leather makes 2 "curved pancake" holsters and an "avenger" holster for the S/W shield 9, RH. Mag pouches include 2 large and 3 small -- so think 1911, Glock 17, Sig 226 for larger versus shield 380, sig 238, P938, pm9, lcp, etc... $50 gets it ALL (this is about 4 sq feet of A grade stuff, with NO waste) Thank You, Jim Share this post Link to post Share on other sites
JLSleather Report post Posted May 8, 2021 23 hours ago, JimNiner said: Hello, I'll take these if they are still available. Thank You, Jim pre-cut leather is SOLD Share this post Link to post Share on other sites
JLSleather Report post Posted May 19, 2021 (edited) 2 presses, some dies (clicker dies, not the liquids), hand tools I'm gonna "bulk" and offer as a package... CHEAP but somebody will want to sharpen some of the edgers, ... Strips and straps, ... vacation coming up soon .. already refunded ALL pending orders and been turning down requests... so.. ALL IN at this point teh cobra 4 stitcher I'd trade for a smaller machine... not sure where i'm headed with that as yet, though apparently the church will get some guitar straps before I'm excused completely 2 part die set, makes RIGHT HAND avenger style holster for either the Glock 43 (shown below) or the S/W shield 9/40. Will include a pattern for one of those pistols. BOTH parts PLUS the holster pattern fer $115 shipped in the U.S. . Note this cuts the entire holster and belt loop, but does not cut the rear slot (that is cut later the way I do it). Edited May 19, 2021 by JLSleather Share this post Link to post Share on other sites
JLSleather Report post Posted May 19, 2021 (edited) Sharp, ready to use. Cuts a 4" square coaster in one hit. Makes a set of 6 in a couple minutes. $40 Billet die $40 Cuts 3/4" wide billet end for ranger belts, case straps, etc. Same die used to cut both ends, guarantees a match, If this isn't something you understand, an example should fix that easy enough. Get em BOTH shipped for $100 even. Edited May 19, 2021 by JLSleather Share this post Link to post Share on other sites
JLSleather Report post Posted May 20, 2021 S/W bodyguard .380 SA XD-M .40 3.8" 1911 A-1 5" $100 gets em ALL Share this post Link to post Share on other sites
Wyle E Coyote Report post Posted May 20, 2021 I am interested in purchasing an item listed here, how do I contact you besides here? Share this post Link to post Share on other sites
YinTx Report post Posted May 20, 2021 (edited) Interested in the Billet die. possibly the holster dies too. YinTx Edited May 20, 2021 by YinTx Share this post Link to post Share on other sites
JLSleather Report post Posted May 20, 2021 41 minutes ago, Wyle E Coyote said: I am interested in purchasing an item listed here, how do I contact you besides here? idunno... I'm gitin purdy good at ignoring the phone these days What were you interested in? I been checkin here least a couple times a day. Share this post Link to post Share on other sites
JLSleather Report post Posted May 20, 2021 holster die and billet die are sold Share this post Link to post Share on other sites
Rodgodwelder Report post Posted May 21, 2021 Can I buy the 1911 blue gun Share this post Link to post Share on other sites
Kwaaked Report post Posted May 21, 2021 I'm interested in the lacing, if you don't mind a newbie asking. Share this post Link to post Share on other sites
JLSleather Report post Posted May 21, 2021 5 hours ago, Kwaaked said: I'm interested in the lacing, if you don't mind a newbie asking. New guys is PREFERRED method Send me a message and i'll gitter in a couple hours - gotta run out fer a bit. Share this post Link to post Share on other sites
Runzeigrun Report post Posted May 31, 2021 On 5/6/2021 at 9:01 AM, JLSleather said: Lace - all leather several spools of 3/32" - 2 black 1 brown 1 spool 3/16" buckstitch lace, black 2 partials latigo lace, 1/8" and 1/4" ALL for $30 (if I remember right, the buckstitch roll was more than that on its own) Available? Share this post Link to post Share on other sites
