vaalpens Report post Posted October 26, 2013 (edited) I decided to scale down one of my holsters and make a holster key ring. Stitching was done by hand and stitching holes were made with a diamond awl. I think the design lends itself nicely to a key ring and the sweat guard works great to hold the split key ring. Burnishing is difficult with such a small piece, so I used some edge kote. The piece was wet formed, neatsfoot oil applied and finished with leather balm. Any comments will be appreciated. Edited October 26, 2013 by vaalpens Quote Share this post Link to post Share on other sites
dirtclod Report post Posted October 26, 2013 It looks pretty neat. But i don't think i would want all that bulk in my pocket. Quote Share this post Link to post Share on other sites
vaalpens Report post Posted October 26, 2013 It looks pretty neat. But i don't think i would want all that bulk in my pocket. Thanks. It is not that big. It is only about 3.5" x 1.5" and does not weigh much. Quote Share this post Link to post Share on other sites