karfar Report post Posted August 22, 2014 I am looking for someone who can make a cover for a Can Am Spyder key. There used to be one available from an online leather shop, however they have discontinued making them. I've attached a photo of the key and the old photo I had saved of the ones that used to be available. The cover cannot be much wider than the key near the top of the shaft, as the key must be able to be depressed while in the ignition and turned to open the gas tank. I can provide detailed measurements or, if you are near Sacramento, CA I can meet you to show you the actual key. There are Spyder clubs all over the country and they are gaining in popularity. Between Sacramento and the Bay Area chapters there are over 100 riders, and new members are constantly being added. I mention this because I know this is a small custom job, but I do think there would be a market for this type of holder. Thank you! Karen Quote Share this post Link to post Share on other sites
ramrod Report post Posted September 11, 2014 this should be a fairly easy job to do ....one would need the actual key for the best results. i would love to help out. but i live on the east coast. Quote Share this post Link to post Share on other sites