Ok, I've been looking for a good skiving machine for a long time. I finally found one, but now I need to get a table and motor for it.

Please do not tell me to contact campbell-randall. That's just not going to happen. I don't feel like getting into a long, drawn out discussion about it, so I will not do so here.

I have read on here that people have used two separate motors for these machines...one to run the knife at one speed of their choice.....and the other motor to run the feed mechanism to feed the material.

Can anyone recommend any machine dealers (NOT the "consew" fake chinese clone salesmen) that would have a table and motor for this machine? The head is a campbell-randall top and bottom feed 81TB.

Thanks for any leads. If I cannot find a source, I guess I will just get a piece of table and route out a hole for the belt and then bolt the motor to the bottom of the table. I'd really prefer one already set up...I just don't want to get ripped off on shipping and so-called "handling" fees.